Now we decrease the PWM value to figure out the lowest usable value. Over which the fan should spin at maximum speed (60): 65Īt which the fan STOPS spinning (press t to test) (100): t Select a temperature sensor as source for hwmon2/pwm2:īelow which the fan should spin at minimum speed (20): 42 Select fan output to configure, or other action:ġ) hwmon2/pwm2 3) Just quit 5) Show configurationĬurrent temperature readings are as follows: What should be the path to your fancontrol config file (/etc/fancontrol)? /etc/tototo The fancontrol script can automatically respond to temperature changesĭo you want to set up its configuration file now (y)?

Please verify that all fans have returned to their normal speed. Would you like to generate a detailed correlation (y)? The pwm outputs connected to the fan connectors,ĭid you see/hear a fan stopping during the above test (n)? Or the connected fan has no rpm-signal connected to one of There is either no fan connected to the output of hwmon2/pwm1, If you do not want to do this hit control-C now!!! This may cause your processor temperature to rise!!! Warning!!! This program will stop your fans, one at a time, Hwmon2/fan2_input current speed: 6136 RPM Giving the fans some time to reach full speed. Physically verify that the fans have been to full speed However, it is ** very important ** that you

The program will attempt to restore each fan to full speedĪfter testing. We will attempt to briefly stop each fan using the pwm controls. Note that many motherboards do not have pwmĬircuitry installed, even if your sensor chip supports pwm. This program will search your sensors for pulse width modulation (pwm)Ĭontrols, and test each one to see if it controls a fan on However automatic configuration for fancontrol did not work in myĬase so here is my manual configuration process: Here is my configuration to make it more silent. The fan control of the NUC is not always perfect, it can make noise when Personnellement qq polys le livre Internet

Linux configure fancontrol